EM - Escola de Minas
URI permanente desta comunidadehttp://www.hml.repositorio.ufop.br/handle/123456789/6
Notícias
A Escola de Minas de Ouro Preto foi fundada pelo cientista Claude Henri Gorceix e inaugurada em 12 de outubro de 1876.
Navegar
2 resultados
Resultados da Pesquisa
Item Resistance factor calibration for perforated cold-formed steel compression members.(2022) Jardim, Roberta Layra Faragó; Freitas, Marcílio Sousa da Rocha; Brandão, André Luis RiqueiraCold-formed Steel profiles are structural profiles widely used in civil construction. They are often manufactured with perforations. The designing can be performed using the direct resistance method. Formulations were adapted by Moen and Schafer (2008) to consider the presence of perforations in these profiles. The objective of this study is to investigate the structural safety of columns with web perforations. The calculation of the resistance capacity was performed using the formulations proposed by the authors. The reliability indexes were determined using the First Order Reliability Method (FORM), First Order Second Moment (FOSM) and Monte Carlo Method (MCM), which are reliability methods for the Load and Resistance Factor Design (LRFD) and Limit States Design (LSD) philosophies. Following the same criteria performed by AISI S100, the resistance factors were obtained from the FOSM method. Based on the results, it was found that the desired security level for the LSD philosophy was not achieved. The calculated resistance factors are predominantly lower than the target. However, for the LRFD philosophy, the safety level was achieved, and the resistance factors were higher than the target.Item Reliability analysis of typical cold-formed steel beams sections.(2016) Campos, Raylza Santos da Silva; Brandão, André Luis Riqueira; Freitas, Marcílio Sousa da RochaThis paper presents a reliability analysis of cold-formed steel beams, based on the FORM and MC simulation and using data obtained from experimental tests performed at the Johns Hopkins University, Baltimore (Schafer, 2003; 2006). This paper approached two sets of flexural tests, one referring to the failure by local buckling, and another for distortional buckling. A failure function is assembled to obtain, by taking into account the statistical parameters of the material (M), fabrication (F), and professional factors (P). The material and fabrication factors were taken from AISI standard. The professional factor was determined by comparing the tested failure loads and the predicted ultimate loads calculated from the selected design provisions. The goal of the paper is the assessment of reliability index for two nominal live-to-dead load ratios, as well as to compare the value found considering the load combinations for ultimate limit states.