EM - Escola de Minas
URI permanente desta comunidadehttp://www.hml.repositorio.ufop.br/handle/123456789/6
Notícias
A Escola de Minas de Ouro Preto foi fundada pelo cientista Claude Henri Gorceix e inaugurada em 12 de outubro de 1876.
Navegar
2 resultados
Resultados da Pesquisa
Item Failure analysis of recurrent cases of fatigue fracture in flash butt welded rails.(2015) Godefroid, Leonardo Barbosa; Faria, Geraldo Lúcio de; Cândido, Luiz Cláudio; Viana, Thiago GomesMedium carbon steel rails are commonly jointed by flash butt welding procedures. To ensure an adequate service life for the structural component, commonly subjected to fatigue loading, a rigorous quality control should be performed, both in welding parameters and in the surface quality of the welded joint. This work investigated the causes of recurrent failures in railroads, with cracking always initiated in the rail in the region of the welded joint. Two case studies are presented. Aiming to execute the failure analysis, all standard procedures were applied, with a careful assessment of the material characteristics and the fractured surface. It was concluded that, for both cases, fatigue cracks initiated near the weld bead and spread in a brittle mode, leading to premature fracture of the material. An in-depth analysis of the rails showed that the surface finishing of the weld bead was not appropriate, generating undesirable stress concentration. Some undesirable microstructural characteristics were also found in the weld region. A recommendation to control welding parameters and to change the procedure of surface finishing of welded joints was held, aiming to decrease the number of accidents on the railroads.Item Fatigue failure of a welded automotive component.(2014) Godefroid, Leonardo Barbosa; Faria, Geraldo Lúcio de; Cândido, Luiz Cláudio; Araújo, Sidney CardosoAutomotive components are commonly tested in fatigue before the final assembly of the vehicle, to ensure the accomplishment of technical specifications of the customer, and to avoid premature failure and accidents with autos. This work investigated the cause of failure of a control arm (component of the automobile movement system), made of high strength and low alloy steel, stamped and welded by robot procedure. The fatigue cracking of the component occurred during the application of standardized blocks of fatigue loading. All standard procedures of failure analysis were applied, with a careful assessment of the material characteristics and the cracked surface. It was concluded that fatigue cracks initiated near the weld bead, at the beginning of the welding procedure. An in-depth analysis of this region showed that there was presence of stress concentration, and the microstructure of the steel has been completely changed, due to an excessive amount of heat at the beginning of the welding. A recommendation to change the welding procedure was performed, ensuring the lifetime specified for the component in the fatigue test.